[<<Previous Entry]
[^^Up^^]
[Next Entry>>]
[Menu]
[About The Guide]
Int 78 Fn 00 - Targa.dev - Cmc International Scsi Device Driver - Set I/ [d]
AH = 00h
DX = interface board I/O port
Return: CF set on error
AL = error code (see below)
Note: if this routine is not called, the port is the driver's default
(usually 0280h or 0300h)
an installation check is performed by TARGA.DEV upon initialization
by checking for the string "SCSI" at offset 03h into the interrupt
handler
See Also: AH=01h,AH=02h
Index: installation check;TARGA.DEV
Values for error code:
00h illegal command given to SCSI code
01h invalid I/O port specified (must be from 100H to 3F8H, and must be on
an 8-port boundary)
02h invalid DMA channel specified (must be from 1 to 3)
03h invalid SCSI board number specified (must be from 0 to 7)
04h error from data register test during self-test
05h SCSI input signals not all 0 when SCSI RST activated
06h SCSI input signals not all 0 before selecting a SCSI device
07h BSY signal is active; SCSI bus is busy
08h SCSI board not selected, BSY signal did not come on in response to
raising SEL
09h time-out waiting for status state, signifying end of DMA transfer
This page created by ng2html v1.05, the Norton guide to HTML conversion utility.
Written by Dave Pearson